Fog Functionality Setup

You can simly use the SHowNET as an ArtNET node, this should work. You can of course use an external ArtNET node with other software but Showcontroller is designed to work with teh ShowNET as node - others may work, but we cannot provide any support for this

Another hint: if you face issues with storing settings to the main board, try using a short LAN cable and directly connect it to the computer. Use Auto-IP for ease of use (DIP 6 on). Then again flash the firmware once again, powercycle, and retry.

If you have a laser with integrated ShowNET mainboard (not external device, only internal ShowNET) and you use the latest Admin Tool version 1.39 and in teh Settings tab there is NO option to switch between DMX IN and DMX OUT, you have a mainboard that has a position equipped with a chip that should not be there. It does not affect the funbctionality of the ShowNET board at all, but it messes with the detection of iternal and external board. Please contact Laserworld Diese E-Mail-Adresse ist vor Spambots geschützt! Zur Anzeige muss JavaScript eingeschaltet sein! to get that board swopped or get instructions how to get that surplus chip off the board.

the external board does not have that option, as the DMX adapter you have to use with it has both in and out at the same time.

The reason why you need to switch is because the mainboard was developed in a way that no other lighting devices get compromised by anything from the laser. If you daisy-chain the DMX signal it is made sure that even if there was an issue with the laser, the rest of the devices in teh chain keep working just fine. That's why the DMX connection is hard wired and does not get processed through the board whith internal ShowNET mainboards.