- Forum
- Showcontroller Support Forum
- Hardware and Installation
- ShowNet Admin - Projection rotated during set-up
ShowNet Admin - Projection rotated during set-up
- Max van de Wouw
- Autor
Weniger
Mehr
- Beiträge: 3
6 Monate 1 Woche her #488
von Max van de Wouw
Max van de Wouw antwortete auf ShowNet Admin - Projection rotated during set-up
Yes, this was indeed the fix. Thank you. I never checked the DMX mode on the mainboards, as I wouldn't controll my lasers over DMX.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- Max van de Wouw
- Autor
Weniger
Mehr
- Beiträge: 3
6 Monate 2 Wochen her #487
von Max van de Wouw
Max van de Wouw antwortete auf ShowNet Admin - Projection rotated during set-up
How odd, will try tomorrow and see if that solves it. Thanks for the reply.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- Super User
Weniger
Mehr
- Beiträge: 69
6 Monate 2 Wochen her #486
von Super User
Super User antwortete auf ShowNet Admin - Projection rotated during set-up
This is not a thing of Showcontroller, but relates to the ShowNET harware laser mainboard, which is what the Admin tool controls.
Solution to your case is simple:
Switch the ShowNET to Professional DMX mode with the Admin Tool, and it will be fine.
Solution to your case is simple:
Switch the ShowNET to Professional DMX mode with the Admin Tool, and it will be fine.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- Max van de Wouw
- Autor
Weniger
Mehr
- Beiträge: 3
6 Monate 2 Wochen her #485
von Max van de Wouw
ShowNet Admin - Projection rotated during set-up wurde erstellt von Max van de Wouw
Found with the newest release of ShowController, when selecting image 255 (grid test pattern) for zoning the laser in the Admin Tool the projection seems to be rotated on the Z-axis by about 45 degrees by default.
However, when storing settings and going into Live this rotation is not present. Like-wise when adjusting for that rotation in the setup, then storing the settings, the output in Live will be rotated. Seems to be a software issue as this unwanted rotation is present in all my lasers:
DS-1000RGBmk2
DS-1000RGBmk3
2x DS-3000RGBmk3
2x DS-3000RGBmk4
PL-10.000RGBmk4
I do not remember this to be an issue with the 2022 release of the software.
Any possible fix that can help me? My current workaround is very time-consuming, so would love a solution.
However, when storing settings and going into Live this rotation is not present. Like-wise when adjusting for that rotation in the setup, then storing the settings, the output in Live will be rotated. Seems to be a software issue as this unwanted rotation is present in all my lasers:
DS-1000RGBmk2
DS-1000RGBmk3
2x DS-3000RGBmk3
2x DS-3000RGBmk4
PL-10.000RGBmk4
I do not remember this to be an issue with the 2022 release of the software.
Any possible fix that can help me? My current workaround is very time-consuming, so would love a solution.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
